MAYTAG MVWX655DW USE AND CARE MANUAL Pdf Download (2024)

FAQs

What are the codes for a Maytag washer? ›

Disconnecting the washer's electricity for three minutes is the simplest way to reset a Maytag washing machine. When the power is cut off, the washing machine's electrical charge can dissipate, allowing it to reset. If the reset doesn't work, unplug the washer once more, this time for ten minutes.

To reset the washer's control panel:

If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the washer is hard-wired to the power supply, turn the breaker off at the home electrical panel that powers the washer for one minute and then turn the breaker back on.

To clear an error code, press pause/cancel 2 times, then press start/pause once. To reset the motor, unplug the machine and plug it back in. Then, lift and close the lid 6 times within the next 12 seconds.

The easiest way to reset a Maytag washer is to disconnect the power to the washing machine for three minutes. Disconnecting the power allows the electrical charge to dissipate from the washing machine, which allows it to reset. If the reset fails, unplug the washer again, this time leaving it unplugged for ten minutes.

Using vinegar in laundry can be done two different ways. "After treating, you can add white vinegar to the fabric softener dispenser in your washing machine," says Cohoon. "Or for a fuller rinse, manually pause your machine right before the final rinse cycle and add a 1/2 cup of diluted white vinegar to the load.

Detergent should never end up in the fabric softener compartment. For one thing, it would miss the actual wash cycle. Putting detergent in the wrong compartment can also result in detergent residue remaining on the fabric, which can cause skin irritations, according to the IKW.

Add warm water and laundry detergent or vinegar to a bucket.

Then, fill it with warm water. Simply swirl the mixture around with a spoon to get it nice and soapy. Alternatively, pour 1 to 2 cups (237-473 ml) of white vinegar inside the dispenser. Vinegar removes residue clogs and neutralizes odors in your machine.

What is the power failure code on a Maytag washer? ›

A PF (Power Failure) error code indicates that the wash cycle was interrupted by a power failure. Touch and hold START to restart the washer cycle or press POWER to clear the display.

The Maytag washer error code F03 E01 means two things. The main problem is your washer's control board can't sense the water level. This could be because of a bad pressure sensor, wiring, a bad control board, or a clogged air pipe.